The Advantages Of Ferrari Approved Certified Pre-owned

Ferrari Approved Certified Pre-Owned Program guarantees that your Ferrari encompassed an array of checks and Factory coverage for cars up to ten years old from the original date of first registration. The program ensures peace of mind to prospects or clients who are considering the purchase of a used Ferrari, it is available at any Authorized Ferrari dealerships in the United States and the inspections are performed by Factory trained technicians. Here is some models belonging to the Ferrari Approved Certified Pre-Owned Program with their respective tech specs.

Ferrari Challenge Stradale
The Challenge Stradale was born to give drivers the performance and feel of a true racing car for road use. In developing the car, Ferrari technicians exploited the Challenge and 360 GT racing type parameters and aerodynamics, with the goal to increase vertical load, improve down force and achieve the lowest possible weight.

Engine: rear, longitudinal, 90 degree V8
Bore and stroke: 85x79mm
Unitary Cubic Capacity: 448.2 cm3
Total cubic Capacity: 3,583 cm3
Valve Gear: Twin Overhead Camshafts
Number of Valves: Five per cylinder
Compression Ratio: 11.1:00
Ignition: Bosch Motronic 7.3 Electrostatic
Coolant: Water
Lubrication: Dry Sump
Maximum Power: 419 hp at 8500 rpm
Specific Power: 116.8 hp/liter
Transmission: rear wheel drive
Clutch: single dry disc
Gearbox: six gears and reverse, F1
Body: two-seater coupe
Chassis: Aluminum space frame
Front Suspension: independent, double wishbones, coil springs, anti-roll bar, gas dampers
Rear suspension: independent, double wishbones, coil springs, anti-roll bar, gas dampers
Brakes: CCM Disc
Steering: rack and pinion
Fuel Tank: 25 gallons
Front tires: 225/35 ZR 19
Rear Tires: 285/35 ZR 19
Wheelbase: 102.4 in
Front track: 65.7 in
Rear track: 63.6 in
Length: 176.3 in
Width: 75.7 in
Height: 47.2 in
Curb Weight: 2,822 lb
Top Speed: over 186 mph

Ferrari 360 Modena
Predecessor of the Ferrari F430, the 360 Modena had an aluminum chassis, body, engine, transmission and suspension. This was a strategic decision that engineers took during the car developing to allow a 34 percent reduction in vehicle weight to consequently achieve better performance and safety standards. Ferrari Formula 1 technical expertise played an important role in the 360 design elements, such as the drive-by-wire throttle, variable geometry intake system and the electro-hydraulic gearbox. The Ferrari 360 Modenas ground effect configuration was also inspired by the Formula One. The underside of the car was in fact shaped to create a low pressure zone in the airflow in order to achieve improved down force for excellent stability at high speeds without any needs for an aerodynamic wing or spoiler.