Kitchen Remodeling - Uninstalling Kitchen Appliances

Because all the different devices, we propose to consult the instructions for the individual device when dismantled. If you no longer have anything or literature is not clear to you, seek professional advice.

Note: If you make adjustments to your kitchen in the past, it would be a good idea to measure the doorways and larger devices before trying to get them through the doors. Samples of old carpet or a large piece of cardboard big sliding devices from a position at the same time, protect the floor from drilling or scratches.

1. Can be mitigated and free electricity from outside the wall far enough to allow you to cut off a thick braid at the rear. Then continue to reduce this group to get out to the kitchen, and put them on a cart and taken to an appropriate place. If the range, oven, fan high, disengagement first communication channel.
2. Drop, and will be installed on the base of the long craft or side tanks. A view from within the range or on the side of cabinets to determine the connection. You will need an additional person to help you raise a range sufficient to deliver and / or turn off the gas. And then lifted onto a dolly.
3. The gas group would have to forward only far enough to get to the closing valve for the gas. Typically, the flexible tubes used to remove will give a little bit. Transfer valve is shut down so tightly. Spare tubes, flexible valve using a small key, and will be able to slide across the room. If you do not plan to re-use the existing gas line, do you want to cut off the supply line as well. Once the main gas valve is off, remove the line width and fill in the appropriate development of gas pipeline, which is inside the wall stud. Once this is accomplished, you can ask the utility company to inspect the gas system and ignite a pilot light for any gas appliances remaining.
4. Wall furnaces will probably be based electric or gas connection, the Council of Ministers without units. Disconnect the cord from the socket or turn off the gas valve and spare tubes, flexible. Then, you can remove the screws that connect the oven to the frame or cabinets - these are usually in the inside of the oven door. Ease forward so could be lifted onto a dolly.
5. Cook tops house also has the power or gas connection in the cabinet at the bottom or perhaps in the cabinet on both sides of the unit. Pull the plug or turn off the gas valve and disconnect from the flexible pipe valve. Removing the unit from the countertop and simply lift it. If you do not plan to re-use gas, and remove the line width and fill in the appropriate development of gas pipeline, which is inside the wall stud.
6. Cook kebabs and top with the ventilation system and down through the floor or down and out of the wall. Determine how the bottom of the vent is attached to the channel; this could be a metal collar that unsnaps or tape on should be off, or it could be held by the lips that nailed or screwed. To disengage the vent. Then unscrew the top of the pillars that attach to cook and raise the unit off.
7. Over the range hood vent houses usually associated electric light under a removable panel or liquidation. Cut this wire and cover them with wire nuts as described earlier. It would be a cabinet doors above the hood to give access, where it connects to the vent duct. Cut this the same way as is shown at the top cooking grill. You will then need to search for the hood to see where there are screws that attach the upper cabinets. Remove screws and lift the hood down and abroad. You may need someone to hold the lid in place while you remove the screws to prevent it from falling before the transfer of all nails.