Installing Sliding Windows As Replacement For Another

By:


Typically, sliding windows are two to three large single-pane windows that - as their name implies - slide to the side to open. First, measure the dimensions of the existing window. A plus to sliding windows is that you can get one custom made to fit any opening. Be sure that the window is about half an inch smaller on all sides than the opening; you need to be able to make minor adjustments to get it level and plumb.

Once you have the new sliding window, check on how the existing window is attached. If nails were used, a claw hammer or other nail puller will be needed; take care not to bend the frame too much or the panes might crack or break. In some cases, the nails can't be pulled. If so, use a reciprocating saw to cut through all of them. If the window is attached with screws, use a Phillip's or standard screwdriver to remove them. Once the frame is free, take it out.

Next, clean the opening; you want any debris live dirt, sawdust, nuts, bolts and screws out of the way. Not only can they damage the new window, but they can cause it to not be level. Once the opening is prepared, lift the window into place; if it's a very large window - get help so as to not injure yourself or chance dropping it. Place a screw on each side of the sliding window to hold it in place, and then use shims and a level to adjust the window to get it as plumb and level as possible. Add the other screws to fully attach the window, and then run a bead of sealing compound around the outside and inside edge.


About the Author:
Learn more about sliding replacement windows and other ideas on windows.



Article Originally Published On: http://www.articlesnatch.com


|

Loading...
Related....
Videos...

Recent Home-Improvement Articles

Comments

Still can't find what you are looking for? Search for it!

Loading

Copyright 2005-2011 ArticleSnatch, LLC - All Rights Reserved.
Privacy Policy | Terms of Service.