Installation Of Sanitary Ware And Appliances

General provisions
1. Toilet, bathtub installed in the ceiling should paint brush (or ceiling), walls with cement mortar Scraping after formation. Low water tank, wash basin (sink) should be installed after the ceramic tile in the wall tiling.
2. Sanitary ware product quality requirements should be consistent with national standards, there should be product certification.
3. Sanitary ware of the connecting pipe, and far-bending should be uniform, not a bump and other defects.
Four. Sanitary ware installation, Expansion bolts should be adopted. Not use wood screws.
5. Sanitary ware support, the installation bracket should be flat, firm, and the apparatus contacts should close.
6. Installation of sanitary ware, protective measures should be taken.

Installation of sanitary ware
1. Use of sanitary ware varieties, specifications, color, etc. should be consistent with household requirements.
2. Sanitary ware and into the water, sewage discharge connection must be tight, no water seepage, leakage phenomenon.
3. Sitting toilet installation, application of lime or silicone oil tight connection.
4. Bath water should be aligned with downspouts, and do a good job sealing, do not use plastic hose coupling. Alignment downspouts Department bathtub dado board should stay 200mm 160mm inspection hole, install a small door. Shower faucet should be installed in the outlet on the same side, cold water on the right, water on the left. Leading position should be correct. Bowl passport should be close to the wall.
5. Washbasin (sink) installation should be correct, hot and cold water pipe joints should be installed under the wash basin, cold water on the right, water on the left.
6. Toilet and water tank installation location should be accurate. Single location to allow deviation of 10mm, the vertical degree of tolerance should not exceed 10mm.
7. Sanitary ware installation height, should satisfy the provisions of 13.2.7.

Monolithic glass mirror installed shall meet the following requirements:
1. Should be painted before installation, mirror on the back of a mirror back paint.
2. Installation should be in the mirror on the back of a layer of plywood and linoleum, with the wall.
3. Screws under the rubber gasket should pad, tighten the screw to the same degree.
4. Mirror behind the application of sealant around the gap embedded real.

Mirror box installation shall meet the following requirements:
1. Mirror Bottom margin from the ground, not less than 1m.
2. Mirror box fixed or mounted on the wall, wall drilling depth of not less than 50mm, wood joints should be embedded in drilling, end inserted into the wall 10mm.

Towel rack (towel ring, towel bar, towel rack, etc.) must be according to the following provisions:
1. Towel ring mounting height from the ground 900-1400mm.
2. Towel bar mounting height from the ground-l100-1200mm.
3. Towel rack mounted on the wall above the bathtub, from the ground 1600mm.
4. Towel rack on the wall should be firmly fixed, fixed office should be clean and smooth.

Bath handle the installation, shall meet the following requirements:
1. Bathtub handle mounted on the top side wall of the bathtub, there are levels, diagonal, vertical three kinds of installation, should be determined according to household requirements.
2. Minimum installation of three ground-fixed dot pitch should as 600mm.
3. Bathtub handle mounted on the wall, should be firmly fixed, fixed office should be smooth and clean.

Project Acceptance
1. Product variety, size, color, etc. should be consistent with household requirements, product quality should be consistent with current national standards.
2. Installation location should be correct there should be no seepage, leakage phenomenon.
3. Sanitary ware and appliances installed after the installation should be no damage, looks bright and clean.