Do It Yourself Faucet Repair Tips

Do It Yourself Faucet Repair Tips

By:


Don't call a plumber! Fixing that leaking faucet is all too easy regardless of how poor a plumber you think you are.

To take on this job you will need a number two Phillips screwdriver, an adjustable wrench, Teflon tape and any type of lubricant for and stubborn or rusted parts. First, turn off the water supply. Generally, you can find the supply lines in your bathroom or beneath the kitchen sink, but just to be safe locate your main water supply and turn it off. Second, you have identify the number of knobs on your faucet because there are differences in repair protocol for each. Let's say, for arguments sake that your faucet is has two handles. For single handle faucets there are little in repair parts and the entire stem should be replaced. If you read on the word stem, and how to remove it to match, will be explained.

The first step to fixing that leak is to take the screws out from the handles using a Phillips number two bit. Once the screws are removed the handles are free to pull off and will expose the stem. The stem can then be turned out counter-clockwise with the use of an adjustable wrench. Once removed you will be able to see that the stem will have some type of rubber at the end. Generally, these are what you would want to replace. If they look chewed or indented the water is by-passing this opening and dripping out of your spout. There will either be a screw to remove the rubber washer or a press in washer that can be removed with your fingernail.

Once you have the old rubber you'll need to swing by your local hardware store to match the size. It is always a better idea to take the entire stem with you, as well as your handle, as they could be a part of your problem.

After procuring the proper repair washer and rubber seals simply replace the washer followed by the screw, or press the washer in until it is flush with the top of the stem. The unit can be threaded in clockwise after wrapping the threads in Teflon tape. Once you have done that, press the handle back on and check to make sure it is properly seated. If it is, simply insert the screw and tighten.

Now you can turn your water supply back on and check your work. If the leak persists check through the steps to ensure that everything was done in order.

About the Author:
Plumber Richardson TX
Plumbers in Dallas Tx
Plumber Plano TX
Plumbing Lewisville
Slab Leak Repair Lewisville TX



Article Originally Published On: http://www.articlesnatch.com


Tags: , ,

|

Loading...
Related....
Videos...

Recent UnCategorized Articles

Comments

Still can't find what you are looking for? Search for it!

Loading

Site Navigation:

Copyright 2005-2011 ArticleSnatch, LLC - All Rights Reserved.
Privacy Policy | Terms of Service.