Bathroom Wall Tile Installation

Bathroom Wall Tile Installation

By:


Installing rest room Wall Tile - Preparation Measure the wall area that's to be covered with tiles. Check for any holes in the wall and patch them up. It is recommended that you use a cement backer board. They're half in. thick and come in sizes of 5X8 feet length and width. Select the acceptable backer board and install them using drilling machine and screws.

Installing bathroom Wall Tile - Working on the Layout Find out the center of the wall with the help of the measurements taken before. Installation should begin at the middle of the wall and end at the perimeters because toilet walls are never completely square. Starting from the midpoint of the wall, chalk the outlines of the tiles to form a layout of all the tiles to be installed. Ensure symmetry, leveling and proper right angled squares while drawing the layout on the backer board. Mark the areas for any plumbing fixtures and modify the layout appropriately.

Installing loo Wall Tile - Installation of Tiles Start from the center line and apply coat of adhesive with help from the smooth side of a notched spade. Use the nicked side of the spade to spread the adhesive. Work in sections while using the adhesive to the backer board. Fix the 1st tile at the center of the layout in a twisted motion to make sure that it has adhered correctly. Similarly place remaining tiles on the backer board. Place the tile spacers after installing each tile so that the width of the grout line between the tiles will be consistent. At the ends of the walls, you may have to chop the tiles in order that they fit into the layout. Employ a tile cutter for the same and employ a higher grit sandpaper to smoothen the perimeters. Leave the adhesive for an overnight to dry.

Installing bathroom Wall Tile - Grouting When you are done with installation of bathroom tiles, begin with the grouting. Choose a grout that's appropriate for the grout width of the tiles. For grout width more than 1 / eight inches sanded grout is utilized, else unsanded grout is used. Prepare the grout according to the manufacturer's direction and take out all the tile spacers. Ensure that the grout you are using is waterproof. With the help of a rubber float, apply the grout between the tiles using a diagonal motion to the grout lines. See that you apply grout completely and the grout has reached the base of the spaces. Rub out the extra grout with assistance from a wet sponge. Leave the grout to dry and clean the surface with a wet material softly, to get rid of any grout remains on the tile. The grout should be left for another day and check out for any grout marks.

You can also apply a grout sealer if you want to, after a week of installation. Now that you understand how to tile bathroom wall, you can re-tile your rest room and enhance your toilet decor. Accuracy and proper layout are the 2 basic needs when installing rest room wall tiles properly.

About the Author:
If you enjoyed this content about dallas bathroom remodeling, then most definitely look into this different internet site about dallas bathroom remodeling.



Article Originally Published On: http://www.articlesnatch.com


Tags: , , , , , ,

|

Loading...
Related....
Videos...

Recent Home-and-Family Articles

Comments

Still can't find what you are looking for? Search for it!

Loading

Site Navigation:

Copyright 2005-2011 ArticleSnatch, LLC - All Rights Reserved.
Privacy Policy | Terms of Service.